Internally Tuned Tambourine Skin Replacement Hello everyone, in our video today How to remove the skin of a internally tambourine? How to assemble a new leather? I will tell you Firstly, What we need Here is an allen key We use to remove and tune the leather Number two allen This way with our allen key the screws here Now expanding I will remove the skin on it In this way We unscrew the screws one by one Yes, Counterclockwise to disassemble We loosen the screws one by one Remove the screws We will also take the leather from its frame. If you want such upright position If you are comfortable, I am so comfortable in an upright position You can also turn it by hand. After loosening all the screws One by one, we remove the screws from their slots in this way. We have totally 5 screws After removing all the screws Already tambour It will come out comfortably. In this way, as you can see, tambourine It’s under the screws here. In our circle We can not disassemble it directly this way So we may need a screwdriver. I will use two screwdriver, maybe you can fix it with one big screwdriver. Compressing the tambour we shove We removed first one I am turning, this time I’m affix it on this side again. After removing two side Easily We can dismantle our tambourines. Right now I’m putting my old tambourines aside. Belongs to Sala Music 22 cm diameter leather I’m mounting it in the circle. Firstly Half of that After putting it in the circle A vast scale We will make the job easier. 1,2,3,4 of them sat down. There’s one left now As you can see, we made our assembly inside the circle After mounting tambourine How to fit it properly? We will take care of it. In this way Let’s check it out We place our screws in their hole. Let’s try to tighten the screws evenly. Its skin will sit straight Firstly fitting the screws we have to provide and feel. My suggestion is to tighten the screws mutually. If we started here, we have to go this way If you tighten the screws mutually the leather will fit better. After tighten the screws Let’s turn around and check Still loose, I’ll squeeze a little more. if you take it this way and tighten it After mounting the full screws Squeezing the skin from here You will see how tightened you are. We go by turning After installing, let’s make sure that all parts are equal. Everywhere must be equal It was a little rough right now. I can loosen it a little more. Because it is a little tough right now counterclockwise I am turning a little bit As you can see we have easily removed and mounting the skin of our tambourine It’s not as difficult as it seems Something everyone can easily do at home. Only the “number 2 allen” will suffice. Thank you for watching us. See you in another video.